Don't drink and gunsmith......

[Cartman]

Thats pretty good

 

[Bushwick100]

So I form 1'd a new lower for a build I'm doing and my wife and I had a few drinks....ok...I had a few more. My KAC trigger guard came in and I guess I couldn't wait and accidentally put the damn thing on backwards; hammered the crap out of it and now I cant get it out. Yes, I'm an idiot, but you all know you've done similar . I even took it to a local gunsmith that I trust and he couldn't get it out either; said I need to take it to a machine shop now.

Any suggestions?

Here's a couple pics; nice looking build other than by botched up trigger guard.

View attachment 868001 View attachment 868002

Thanks for the laugh, I hope you fix it.

 

[Tactical Beaver]

Have you tried loading the mag in backwards? Just a thought...

tried putting that clip in upside down too....

 

[payneed]

tried putting that clip in upside down too....

You sir are going to have the last laugh when that thing will shoot targets behind you!
Good luck, I have no constructive comments, maybe take it to @Nonliberal ?

 

[Butshot]

Yes, I'm an idiot, but you all know you've done similar
No, no I haven't, don't drink and drive and don't drink and smith!

 

[Wolf six]

You can use a drillbit that is only slightly larger than the inside diameter of the roll pin. Drill it out and screw in an easy out and use a pair of pliers to pull it out

Like this? http://www.slingshottools.com/irwin...t-53700.html?gclid=CJaq6fC1vM4CFdcXgQod7uYHwA

For the lower? I'm not selling it.

 

[sparked1]

I feel your pain. I once put on a magpul front BUS backwards. lol

At this point, I would probably drill (or have a machine shop drill) a hole on the opposite side to drive out the pin. Not sure if that would compromise the integrity of the lower but I doubt it.

Or you could just cutoff the trigger guard and then cut through the middle of it (through pin) and carefully pry off each half. All it takes is some finesse, a Dremel, and another 12 pack.

 

[dixieammo]

Like this? http://www.slingshottools.com/irwin...t-53700.html?gclid=CJaq6fC1vM4CFdcXgQod7uYHwA

Thats it just becarefull with the small bits

 

[Cartman]

When you break that small drill bit or easy out, I will still buy it from you. I can get them out too.

 

[StuP]

You could try to modify a harbor freight chain breaker. You'd need to grind it to fit, but they're a good cheap way to press out stubborn pins.

http://www.harborfreight.com/heavy-duty-chain-breaker-66488.html