Dobbs Defense in Dallas could probably get you taken care of!
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
this may sound stupid but anybody with a bit of common sense and a battery drill can dimple a barrel for a gas blockNot looking to dimple the whole thing, just two dimples where the set screws go for the GB.
I stressed over this for a long time myself. Then I ordered a barrel from Faxon and asked them what they do. They sell a gas block with three set screws.
They told me they do not dimple the barrel. They use Loctite.
I asked the people at Troy about their gas blocks. They said they do not dimple the barrel. They put Loctite in them and stake the set screws like you do the gas key on the BCG.
It may seem simple to some of you, but when you're contemplating destroying a new barrel, it's not easy to make that kind of decision. Besides common sense tells me if you drill into the barrel like that, it would weaken that area.
I'm going to do Loctite and staking the set screws. The OP is encouraged to do that or take his chances.
I always use my debt card or credit card to space the gas block off the shoulder and use a drop of blue loctite on the set screws and never had a problem. I agree with them. However I'm not opposed to dimpling the barrel in a correct manner as I have done it a few times for friends builds who wanted it done that way. As far as weakening the barrel I don't prescribe to that point of view because u do realize u have a gas port in the barrel. It never fails, so I don't think 2 dimples affect the integrity of the barrel.I stressed over this for a long time myself. Then I ordered a barrel from Faxon and asked them what they do. They sell a gas block with three set screws.
They told me they do not dimple the barrel. They use Loctite.
I asked the people at Troy about their gas blocks. They said they do not dimple the barrel. They put Loctite in them and stake the set screws like you do the gas key on the BCG.
It may seem simple to some of you, but when you're contemplating destroying a new barrel, it's not easy to make that kind of decision. Besides common sense tells me if you drill into the barrel like that, it would weaken that area.
I'm going to do Loctite and staking the set screws. The OP is encouraged to do that or take his chances.
Although that is partially true, asthis may sound stupid but anybody with a bit of common sense and a battery drill can dimple a barrel for a gas block
I stressed over this for a long time myself. Then I ordered a barrel from Faxon and asked them what they do. They sell a gas block with three set screws.
They told me they do not dimple the barrel. They use Loctite.
I asked the people at Troy about their gas blocks. They said they do not dimple the barrel. They put Loctite in them and stake the set screws like you do the gas key on the BCG.
It may seem simple to some of you, but when you're contemplating destroying a new barrel, it's not easy to make that kind of decision. Besides common sense tells me if you drill into the barrel like that, it would weaken that area.
I'm going to do Loctite and staking the set screws. The OP is encouraged to do that or take his chances.
Dimple it, then drill through it and pin it
Absolutely, 100% bombproof. Unfortunately I don't have a jig for the pin. They actually provide the coil pin too, which only requires a straight hole. Much easier versus drilling and then reaming for a 2/0 taper pin.The Geissele rail I bought came with a Geissele GB.
Not only does it have 2 set screws but it has holes on the side so you can drill through and pin it in place.
If you do that I think it would be pretty much bomb proof.