Stuck buffer tube detent

[Shovelhead]

Andy is both hard to get in touch with and sits on a backlog of work ... this is because he does good work!
But he is nearby up off highway 9 near the Grasslands Walmart ...

From a very good source.. seems the C3 billet lower detent pin hole has a history of being undersized Just need to visit Andy......

 

[opps]

He has had some health issues and is always back logged. If you can reach him on the phone- maybe he can take a look at it while you wait. Super guy.

 

[Shovelhead]

Took some work but I got it. I dremeled off the tip then sliced a slot across it. Took a screwdriver and hammer like an impact wrench. Tapped
a few hundred times and it came out. I then "cleaned" out the hole. Either the hole was under sized or the detent pin was oversized and/or
glued in... I dont care at this point.

 

[b.a.customkydex]

I might have a new detent if you need it

 

[Shovelhead]

I might have a new detent if you need it

Thanks for the offer but have one in spares....along with the spring I usually lose when it goes flying...