Design ideas for the next ODT lower? - Update 2

[Okuma]

Update 2

Ok everyone, I think it is about time to get going on this again, assuming there is enough interest and we can agree on a design..

We are just in the design phase and will be shooting for November or December to open up orders. (These will be pre-order only.)



Update 1


I think we are going to go with one lower per year and hold off on doing a run until the end of this year, but we can still go ahead and try to figure out a design that a majority of us like.

Just post ideas in here and be sure to speak up if you like a particular design or idea. After a couple months or so we can start narrowing it down and do some voting on them.

 

[Shovelhead]

Go billet on the next one... and I'm in... Actually I'm in for a forged lower as well

 

[Patronus]

Do it via a workshop in making a lower so we can make our own. That way we can make one for ourselves and don't need serial numbers on them.

 

[jwhited]

Milled AK receiver?

 

[Al Capone]

How many of these already been done?

 

[Brandon031]

Do it via a workshop in making a lower so we can make our own. That way we can make one for ourselves and don't need serial numbers on them.

I like this idea lol

 

[Okuma]

None of these are design ideas

 

[jwhited]

None of these are design ideas

OK. Two chickens.

 

[Okuma]

OK. Two chickens.

I like it!

 

[strider12]

Umbrella corporation logo.

Does it have anything to do with ODT?

Absolutely not. But lots of people would want it.