I am starting to put together a little area in the unfinished section of my basement for reloading. I'm also trying to be as cost effective as I can on things like the table, etc. so I can put my $$$ towards a nice Dillon 550C. We had this well built table (my wife's old kitchen table from her first marriage that was sitting in our laundry room doing nothing but collecting dust) and I am going to use that as my "work bench". My only concern is the rounded edges of the table and the way the Dillon press appears to be shaped for securing to a table top. I assume I could just file/sand the section where the press is down flat and be fine...curious for others opinions.