sks project conversion to ak mags UPDATED WITH HOW TO VIDEO

[$nipertime]

Look at the two previous videos there mine. I would consider doing another one but only for myself. Using only a dremel was a pain but if I had a small mill I could do one in two hrs

 

[1coolhand]

Looks great! Very impressed!

 

[$nipertime]

Thanks guys. I ended up putting it in the Tapco stock and ran about 700 rounds and 18 different mags through it today. Ran flawless with soft point ammo. 0 fail to feed. Did however have one stuck hull the bolt pulled the lips off the cartridge

 

[gth813x]

so question, does that mean you can feed the AK mag with stripper clips now? i'm assuming no

 

[$nipertime]

sorry I have been out of the country and am going to revive this thread to answer the question, No I did not take it that far