Look for marks under the scope mounts, bet there covered up.
-
ODT Gun Show & Swap Meet - May 4, 2024! - Click here for info
Little help here fellas
- Thread starter allamericaninfidel
- Start date
If thats considered cheating...it a Mauser that had an aftermarket bolt installed as part of the "build"
nothing under mount -
Markings under chamber
I was looking at the Mauser Chopper posted. Looking back at your gun...is the barrel stepped down and is there a stripper clip guide?
the barrel steps down after the chamber at the start of the old rear sight base - yes on the stripper clip guide - however its been ground off on one side - whatcha thinking ?
Sure seems like an early 1903. You can note the big cocking nob and the way the barrel doesnt step down in the middle like most Mausers...maybe the markings have been removed?
wont chamber 30-06 round and barrel much smaller than 30 cal. - 270ish size
Alot of 7mm sized Mausers out there...but the knob and barrel. Someone could have rebarreled it, but you sure dont see alot of rear sight bases put on them.
