Working on “installing” this compensator and something isn’t lining up...
Here’s timing as the compensator is fully tightened onto the barrel:
When I back it off to proper timing, torquing the set screw to spec still leaves the compensator spinning freely:
I’m worried about either stripping these aluminum threads, or applying loctite (specified not to be required) and still having a loose comp.
**** me, this shouldn’t be complicated.
Here’s timing as the compensator is fully tightened onto the barrel:
When I back it off to proper timing, torquing the set screw to spec still leaves the compensator spinning freely:
I’m worried about either stripping these aluminum threads, or applying loctite (specified not to be required) and still having a loose comp.
**** me, this shouldn’t be complicated.