What have you reloaded today?

[thevalueman]

Have you ran the 155gr XTP’s at 7.3gr of CFE-P already?

I see it’s a tad over max per Hornady manual but I’ve done a similar load on a 124gr XTP and happy with the results. I just know 40sw can get extremely high pressure with a QUICKNESS.

the books today post lower loads(insurance) than they used to....

 

[Talos]

Nothing, waiting for this gat dang rain to go so I can cast some 9mm, 45acp, and 44 mag.

 

[Hunterrs]

45 rounds of 6.5 Creed. Winchester brass, CCI #200 primers, 140g ELD-M over 40g of H4350.View attachment 3833379

Do you run into any small rifle primer brass loading the 6.5? I bought a couple of hundred from Ga brass and only one was small.

 

[Plumminfool]

I’ve never seen a small primer creed.

 

[Adam5]

Have you ran the 155gr XTP’s at 7.3gr of CFE-P already?

I see it’s a tad over max per Hornady manual but I’ve done a similar load on a 124gr XTP and happy with the results. I just know 40sw can get extremely high pressure with a QUICKNESS.

I’ll be running some after work one day this week. The load it just below the 7.4 max that Hodgdon shows for it.

 

[Rolling_trip]

Reloaded all the 38 spl brass I had today(148). Everglades flat point plated 158 gr, with 6.1 gr of Accurate #5. Test fired 20 rds out of my Henry X and Obsidian 9. Stupid quiet and stacked on top of each other.

 

[thevalueman]

Do you run into any small rifle primer brass loading the 6.5? I bought a couple of hundred from Ga brass and only one was small.

all my 6.5 is small primer.....

 

[owen58]

The toilet twice

That cracked me up so bad, I couldn't even chamfer my brass.

 

[thevalueman]

a comment on a year old post....
now, that cracks me up!!

 

[owen58]

a comment on a year old post....
now, that cracks me up!!

Can't help it. Each time I see the OP page that comment cracks me up.