Unpinning AAC muzzle device & re-installation w/o damaging threads

[marksman17]

What do yall think? Do you think this AAC muzzle device could be unpinned from the current gun and re-installed to another suppressor host(non pin/welded) without damaging the ratchet mount threads. AAC 90t devices are super hard to find, and I dont wanna risk damaging the mount by switching cans around on guns. The weld is pretty close to the mounting teeth which worries me. Havent taken it to QRF or GaFL yet for them to check it out and get their opinion yet, but just wanted to get yalls ODTer expert opinions. Pics for original pin/weld job and current condition (not that it matters)

 

[KingTuna]

Id message cmshoot and ask him this question. Im aure he would recommend a gunsmith that could do the work if it is possible.

 

[Atlanta Rifleworks]

I can do it. Send me a PM

 

[gyppo]

Are you going to try to salvage the barrel?

 

[AK74U]

Cant wait for the final product!

 

[blazedawg87]

Any competent machinest/Smith can do it. Cmshoot is who you need to contact

 

[rightway1974]

Use a mill.

 

[ReservoirDawg10]

Vote for Atlanta Rifleworks . Super clean p/w jobs

 

[marksman17]

Are you going to try to salvage the barrel?

I better be...

 

[FLGA]

I can do it. Send me a PM

Vote for Atlanta Rifleworks . Super clean p/w jobs

He does my work.

A+ Quality

Depends more how the original job was done, but if it can be done, Tony will take care of it