finally getting around to building a dedicated reloading bench. I've got about 15' or so to play with. Been looking at some butcher block slabs for the top of the bench (3 sections each is 50"x26"x1.5") and cabinets underneath on either side and then a gap in the middle so if I want/need to sit at the bench I can get my legs under the bench and use it like a table. Photo I got from the internet, but like on the left side but with standard cabinets.
More than likely will add some shelves/cubes above the table for powder and bullets and other random things. Like the photo here:
Any thoughts on the layout, materials, etc? I've got an RCBS single stage and a Dillon 550 that will probably stay fixed in place, and then a variety of other accessories that I will probably figure out some way to make them interchangeable on the top so they aren't all stuck up there all the time (crimp remover, cast sizing setup, trimmer, etc.)
More than likely will add some shelves/cubes above the table for powder and bullets and other random things. Like the photo here:
Any thoughts on the layout, materials, etc? I've got an RCBS single stage and a Dillon 550 that will probably stay fixed in place, and then a variety of other accessories that I will probably figure out some way to make them interchangeable on the top so they aren't all stuck up there all the time (crimp remover, cast sizing setup, trimmer, etc.)