Factory 2" receiver hitch off my '99 F250.
Never saw any substantial towing just couple of small boats and utility trailers over the years.
Light rust (it's 24yrs old) but good used cond hitch complete with factory mounting hardware so it's ready to bolt up and use in 15 minutes! Clean (not wallered out!) 5/8" pin hole.
Will fit a variety of F250/F350 model years and should bolt up to the Ford Excursions as they were F250 chassis and it may even work on older Dodge/Chevy frames with the 34-1/4" mount hole width.
Heck if you're a welder/fabricator you could make this strong receiver hitch fit just about anything!!
Must meet local to the Canton / Ball Ground area.
$60.00 OBO
Never saw any substantial towing just couple of small boats and utility trailers over the years.
Light rust (it's 24yrs old) but good used cond hitch complete with factory mounting hardware so it's ready to bolt up and use in 15 minutes! Clean (not wallered out!) 5/8" pin hole.
Will fit a variety of F250/F350 model years and should bolt up to the Ford Excursions as they were F250 chassis and it may even work on older Dodge/Chevy frames with the 34-1/4" mount hole width.
Heck if you're a welder/fabricator you could make this strong receiver hitch fit just about anything!!
Must meet local to the Canton / Ball Ground area.
$60.00 OBO