help with ruger mkIII hunter

[GoDawgsGo]

So I purchased the majestic arms speed strip kit a while back for my wife's mkIII hunter. Well tonight I finally decided to try and replace the hammer with the one that is sent with the kit, and now the gun is in pieces and I cant get it back together. I've looked at the videos on how to completely reassemble the gun but I cant get it back right. So does anyone know of someone close to clayton county that could help me get this thing back together, or is there anyone on here that can help me please let me know thanks.

 

[RamRoddoc]

Sorry but I kind of ignored all the writing. My dad says to turn it upside down to put it back together. This is a common occurrence. Hope it helps, if not someone who has taken these apart will step up and spoon feed you soon enough.

 

[GoDawgsGo]

Yea that's why I got the kit to make it easier and quicker to take a part, but I have taken it way apart not just the average break down. I just cant deal with the little parts around the hammer my freaking fingers are to big.

 

[acman]

I had a mark 2. It was a pain to reassemble. Had to watch several you tube videos and kept trying to get it back together. You have to follow each step

 

[Old_School]

Yea that's why I got the kit to make it easier and quicker to take a part, but I have taken it way apart not just the average break down. I just cant deal with the little parts around the hammer my freaking fingers are to big.

I've never taken apart a MkIII, only the MkI and several MkIIs. Here's the best breakdown I've seen, but I'm not sure if it applies to the MKIII and the additional parts it has for the magazine safety.

http://www.1bad69.com/ruger/internals.htm

Here's some specifics on the MkIII series:

http://www.guntalk-online.com/detailstrip.htm

Hope this helps!

 

[GoDawgsGo]

I realize I need to follow the steps. The gun is small and the parts are small and Im just frustrated with dealing with it.

 

[GoDawgsGo]

I've never taken apart a MkIII, only the MkI and several MkIIs. Here's the best breakdown I've seen, but I'm not sure if it applies to the MKIII and the additional parts it has for the magazine safety.

http://www.1bad69.com/ruger/internals.htm

Here's some specifics on the MkIII series:

http://www.guntalk-online.com/detailstrip.htm

Hope this helps!

Thanks bud Ill try that tomorrow

 

[Old_School]

A small pair of needle nose pliers, forceps, and punches for aligning parts with the holes helps when reinserting the pins.

 

[GoDawgsGo]

Ok im done with it anyone know of a good gunsmith that can help get this thing back together.

 

[RamRoddoc]

Ok im done with it anyone know of a good gunsmith that can help get this thing back together.

Ray at Moss Pawn Jonesboro area is well respected in the area if you are near the South side. http://mosspawnandguns.com/