Glock, easiest gun in the world to fix /update?

[Jester7]

I don't know but it's pretty damn easy. I needed to install a new pin in my G17 (I bent one if you can believe it) so I went ahead and installed an extended Slide lock and Slide stop level and replace both the medal pins... total time, about 5 minutes. Today I installed a set of TFO sets... about 10 minutes and that included a small amount of filing to make the sights fit perfect.

Love or hate the Glock... gotta love that.

 

[gth813x]

Do it a few times and you'll get it down to less than a few minutes. Get real good at it after installing a ghost rocket.

 

[rtross]

Glock is the bomb!

 

[jwhited]

Do it a few times and you'll get it down to less than a few minutes. Get real good at it after installing a ghost rocket.

Haha yep, you quickly learn how to take apart a Glock without pulling the trigger.

 

[gth813x]

just need a couple paper clips or an itty bitty allen wrench

 

[BackWoods]

If you can't Duct it! **** it!

 

[Jester7]

Do it a few times and you'll get it down to less than a few minutes. Get real good at it after installing a ghost rocket.

I coulda been faster... was watching TV and discussing stuff with the wife

(I only use duct tape on my hipoints.... just kidding, don't have any...)

 

[Swann25]

Gotta love them. Watched one video twice now I can completely disassemble it in a matter of seconds.

 

[protective measures]

I did a complete detail strip on an old Gen II G-19 that's serial number started w/A**.
It had quite a few rounds down the pipe as you would imagine.
Did all of the armorers tests on it, checked all of the springs, & it was good to go other than some old burnt powder residue.