Search results for query: *

  1. Where can I find a bag of shot?

    Oaisis Shot Maker. Good folk
  2.

    Ok, need some help

    If they were once fired shouldn't be anything in there. If you weren't the one that shot them it looks like the work of a bored 5 year old. Usually you'll find dirt, stuck tumbling media, bugs, spider webs etc. I'm thinking bored kid.

  3. Has anyone

    Has anyone ordered powder directly from Hodgkin's website? Or is it a scam?

  4. lee pro 1000 quit indexing

    I've been through the Dillons too. At my age the Lee is plenty fast but it's only used for small straight wall pistol brass.

  5. lee pro 1000 quit indexing

    I still use the old 3 hole Lee turret press. When it stops turning the turret I have to change the little plastic gear tooth thing inside the clamp on the ram. I use the same plastic ratchet thing as the 1000 does. I have found that some of the plastic gear things are slightly too big around...

  6. Lee 1000

    Each type press has it's good & bad points. So the right answer is have BOTH.
  7.

    Powder and primers Country Sportman -west Rome GA

    Later, if dollar goes worthless those prices will be reasonable.

  8. 30.06 for M1 Garand? Easy to Reload?

    Do it so you'll always have ammo. Over buy your supplies so you're good for YEARS.

  9. 38 spl brass

    Stay with recommended sellers. Lots of fraudulent sites.

  10. Fixing to have a pull down project.

    I think you need to verify your scales. Maximum bullseye is 4 gr. So it should function. But I think your scale is off.

  11. CCI LRP

    Midway. NOW

  12. Smelting pot clogged

    Get a propane torch and heat the spout while tapping on it.
  13.

    Who the heck would order Blemished primers?

    If they popped I'd use them. I actually posted to give a shout out to Everglades Ammo. I don't know if their prices are the best but shipping speed is unusually fast. (Bullets & brass for reloading).
  14.

    Well it's a start.

    You'd be surprised how well an unopened roll of insulation works if the barrel is gently inserted a couple inches in center of roll.
  15.

    Powder Burn Rate Chart

    Maybe this will be helpful to newer reloaders

  16. Serious question,

    Choot em. Doubt you'll notice any difference

  17. So I use to use RCBS reloading equipment.

    My son set up his own reloading room and got the newfangled (to me) digital powder measure. It was accurate at first but then began giving very erratic charges. Turns out that his cellphone was too close to the measure. Y'all should be aware this can happen. I'm stuck in the dark ages with...

  18. Seriously though..............................

    If it's all been shot and you're in immediate need of 3 more it's value will decrease, you might too. But if it's loaded ammo? Value could soon be PRICELESS.
  19.

    Well it's a start.

    I think you'll be needing to brace the front edge more. Sometimes you really get down hard on the press, down and up. And hand good light over your bench.

  20. Which 45/70 die set?

    These days feed it any bullet that fits. You're lucky to find it. I have found some Hornady brass to be slightly short once fired and just short enough that it prevents a decent crimp on the reload. It may have been a one time thing but keep in mind the brass could be below length. With cast...
Back
Top Bottom