Ultrasonic Cleaner for rimfire

[Dave550]

New to rimfire cans. Got a Dead Air Mask and looking for a good but inexpensive ultrasonic cleaner- probably from Amazon or something. Any suggestions from people with experience?

 

[BHPSteel]

I bought one of these:

Amazon.com

I preferred dials over buttons, and the model I got was a 2 liter, but that model is being offered at a great price.

Most of the inexpensive units are all built by the same company with pretty much the same parts. They're all subject to the same kind of limitations.

 

[Dice]

New to rimfire cans. Got a Dead Air Mask and looking for a good but inexpensive ultrasonic cleaner- probably from Amazon or something. Any suggestions from people with experience?

harbor freight has one that will do the job.

 

[Twitch2120]

Rotary tumbling. Makes em look like new. Makes brass look new too if you reload.

 

[Timber Cruiser]

I bought the little Hornady one for my Oculus. Works fine.

 

[ReservoirDawg10]

Stainless pin tumble. You'll never go back to ultrasonic for suppressor ckeaning

 

[Construct More Pylons]

As a member of team lazy, I ultra sonic clean cans. Just grab one off Facebook market place.

 

[Going Postal]

Ditto on the SS pins, I just throw be baffles in with a load of brass that I'm tumbling. I usually just wipe down the "tube" with Hoppes #9, inside and outside.

 

[Spikey]

I soak my baffles in Fluid Film for 48 hours before ever shooting them. 500 rounds of .22 thru different cans , take apart and wipes clean 90% of the crud . Soak again when I reassemble .