-
ODT Gun Show & Swap Meet - May 4, 2024! - Click here for info
Ruger precision
- Thread starter mfoster
- Start date
- Status
Measuring for scope rings
1. Mount your base to the rifle.
2. Stack washers (or pennies, nickels, quarters, etc) in even stacks on the mount about where your rings would go. Build the stacks up until you get the scope at the ideal height that you want.
3. Take one of the washer stacks and measure the height (preferrably with calipers). If you do not have calipers, the average penny is .0593”.
You will now have your ideal saddle height (top of the base to the bottom of the scope body or tube). In the accompanying photo, that is height "B".
You will want to purchase a set of rings with a "B" height as close as possible to what you measured from your stack of washers
When purchasing your rings, if they are sold using height "A" (top of base to center of ring) then you will need to:
Add .5" to your washer measurements if you have a 1" scope tube
Add .59055" to your washer measurements if you have a 30mm tube
Add .66929" to your washer measurements if you have a 34mm tube
Add .688975" to your washer measurements if you have a 35mm tube
Alternatively, you could subtract those numbers from the "A" height of the scope rings manufacturer's specs and that would give you the "B" height, it'll work either way.
1. Mount your base to the rifle.
2. Stack washers (or pennies, nickels, quarters, etc) in even stacks on the mount about where your rings would go. Build the stacks up until you get the scope at the ideal height that you want.
3. Take one of the washer stacks and measure the height (preferrably with calipers). If you do not have calipers, the average penny is .0593”.
You will now have your ideal saddle height (top of the base to the bottom of the scope body or tube). In the accompanying photo, that is height "B".
You will want to purchase a set of rings with a "B" height as close as possible to what you measured from your stack of washers
When purchasing your rings, if they are sold using height "A" (top of base to center of ring) then you will need to:
Add .5" to your washer measurements if you have a 1" scope tube
Add .59055" to your washer measurements if you have a 30mm tube
Add .66929" to your washer measurements if you have a 34mm tube
Add .688975" to your washer measurements if you have a 35mm tube
Alternatively, you could subtract those numbers from the "A" height of the scope rings manufacturer's specs and that would give you the "B" height, it'll work either way.
- Status
