Hi is there someone in the local area (N. Gwinnett) that could help me remove my p&w muzzle device off of my upper? Can compensate for time. Thank you.
-
ODT Gun Show & Swap Meet - May 4, 2024! - Click here for info
removing a pin & welded muzzle device
- Thread starter Sean Lee
- Start date
- Status
I’m nowhere near you but I can say, having done it…use a dremel, take your time…don’t rush it. It’s very easy to do if you’re patient.
Hmm ya don’t know if i want to run out a get a dremel but may have to come to that point
I don’t know that I would try it without one…what were you planning on using?
Lacking in grinding tools at the moment thats why I was seeing if there’s someone near me that could assist with that haha. Thanks for the suggestions though!
Gotcha…a Dremel is a good investment though…you’ll be surprised how handy it becomes in other situations. Every tool collection should have one. Mine is over 20 years old.
I do this as a paid service. I use a mill and just cut it right off. Fast and painless. I don't know if Ive ever done just a Removal with out reinstalling a different device and pinning it. I'm also not close to you.
PM sent.
You can buy a cheap dremel tool at Harbor Freight for probably 20 bucks or better with coupons. It will suffice for a quick job. Normally I don't cheap out on tools but if you are just going to use it a few times a year it will hold under those loads quite well.
- Status
Similar threads
