Reloading question Help

[1006]

Maybe it was the seating die.

Either way, not a good idea to run a completed cartridge into a sizing die. Even with the decapping pin removed, you are squishing the bullet diameter.

 

[firefighter1949]

What he meant to say was he ran a loaded round back through his CRIMPING DIE. Don’t let them give you a hard time!! “Being new at anything Su***! It is PERFECTLY SAFE!!

 

[bow777]

Thanks FireFighter!

 

[greg vess]

A resizing die shapes the outside as well as the inside. In order to correct case mouth it goes down inside the case mouth as well. If you run a charged cartridge with a projectile in it, it will push the projectile down into the case.

 

[greg vess]

You possible break the die. Push the projectile to far down where you can't get it out. I would avoid that at all costs. That's if I am reading your post right. If not disregard this post. Also the one before it.

 

[Seacap]

Did u lube them all down again?...I would be hesitant to tumble them to clean them up!