Need Good Carpenter. Project Completed.

[Stuckon22]

Was going to build one myself but herniated a disc......again.
I need a pressure treated work table built. It will be used outdoors only. Dimensions need to be 10 ft long, 5 feet wide, 44 inches high. Prefer it to be screwed together with lagbolts rather than nailed. Corner posts should be 4x4 or 4x6 posts at least. Table top needs to be similar to decking with few cracks as possible between boards may be better to use the synthetic type of decking to not have shrinkage or swelling as again it will be used outdoors). Would also like a lower shelf under it approximately 24 inches off the ground. If you or someone you know can build it and deliver to Acworth please PM me with a quote and I will fill you in to clarify exactly what I am wanting. Will pay cash and/or firearms. Thanks, Billy

 

[Stuckon22]

Will pay cash or cash and/or firearms also.

 

[sc951]

PM sent

 

[BLIP]

Kind offer.

 

[moosensquirrel]

Suggestion: Treated lumber is not what it used to be. Unless a lag bolt is pilot drilled, it will eventually split the wood and be a source of rot. I recommend carriage bolts, nuts with fender washers.

 

[Stuckon22]

Thanks to sc951 for working up a quote for me. Both my boys were having pity on me since I herniated a disc so I designed this. They did the hard labor while I supervised, measured, and did the cutting. It turned out to be larger than I thought, 5x heavier than I thought so it will be a permanent fixture here at the house...lol. Would take a crane to move it. So here is the dinner on the grounds/game cleaning station/work table/wife's flower pot table(until deer season...lol). All total I have about 350.00 in it. Thanks again for the responses. Mister Heavyhand thanks also for offering to lend a hand.

 

[Redneck1919]

Sweet. Can do double duty to hang trespassers.

 

[Stuckon22]

Sweet. Can do double duty to hang trespassers.

My wife said it reminded her of the gallows in an old western....lol

 

[Mister Heavyhand]

Like the counterweight! Nice job. Put some steps on there and you can use it also for a milking stand for the goats.

 

[Stuckon22]

Like the counterweight! Nice job. Put some steps on there and you can use it also for a milking stand for the goats.

I think if I got the right ramps I could pull the atv on it to work on..lol.