I am getting into 300BO reloading and decided to buy a little cutoff jig for use with a 2" trim saw. While looking around for a jig and trying to decide which specific model to pick up I noticed on eBay somebody selling one that appeared to be 3D printed. I checked, sure enough there was a 3D model (actually several) for download out there so I printed this last night. Cost me a whopping $.53 worth of plastic to print! It just clamps in the little vise on the cutoff saw. Manually move it side to side to set the OAL you want. If it gets destroyed I'll print a new one!