• ODT Gun Show & Swap Meet - May 4, 2024! - Click here for info

How do I tap suppressor sights out of a p320?

151   0
Joined
Nov 11, 2020
Messages
1,298
Reaction score
946
Location
Warner Robins
Normally I would just push out the sights with the sight pusher, but with suppressor sights, and big ass guide rod port on the slide that's not happening. I bought a nylon punch so I don't scratch the metal, but after about 10 minutes of pounding I only got it about 2mm or so.

Can anybody tell me how it's done so I don't say frick this and bubba it with a metal punch?

Thanks!
 

Attachments

  • 16338944287768217279474169644437.jpg
    16338944287768217279474169644437.jpg
    129.7 KB · Views: 26
Make sure you’re driving it in the right direction. Usually, you drive them out from left to right.

On difficult ones, I use heat from a heat gun, and a brass punch.
I think I drove it in the wrong direction I went right to left... nylon still ain't cutting it though. Just bought a $35 8 piece brass grace usa punch set online, another vice would be better too.

It's expensive as hell feeding a gun addiction
 
I think I drove it in the wrong direction I went right to left... nylon still ain't cutting it though. Just bought a $35 8 piece brass grace usa punch set online, another vice would be better too.

It's expensive as hell feeding a gun addiction
I keep telling people hookers and blow is cheaper but no one listens
 
Back
Top Bottom