How do I tap suppressor sights out of a p320?

vulture man

Default rank <1000 posts Supporter
Frontiersman
98   0
Joined
Nov 11, 2020
Messages
851
Reaction score
615
Location
Warner Robins
Normally I would just push out the sights with the sight pusher, but with suppressor sights, and big ass guide rod port on the slide that's not happening. I bought a nylon punch so I don't scratch the metal, but after about 10 minutes of pounding I only got it about 2mm or so.

Can anybody tell me how it's done so I don't say frick this and bubba it with a metal punch?

Thanks!
 

Attachments

  • 16338944287768217279474169644437.jpg
    16338944287768217279474169644437.jpg
    129.7 KB · Views: 22

vulture man

Default rank <1000 posts Supporter
Frontiersman
98   0
Joined
Nov 11, 2020
Messages
851
Reaction score
615
Location
Warner Robins
Make sure you’re driving it in the right direction. Usually, you drive them out from left to right.

On difficult ones, I use heat from a heat gun, and a brass punch.
I think I drove it in the wrong direction I went right to left... nylon still ain't cutting it though. Just bought a $35 8 piece brass grace usa punch set online, another vice would be better too.

It's expensive as hell feeding a gun addiction
 

Twitch2120

Default rank <3000 posts
ODT Junkie!
8   0
Joined
Aug 12, 2011
Messages
2,892
Reaction score
1,347
Location
NE Burbs
I think I drove it in the wrong direction I went right to left... nylon still ain't cutting it though. Just bought a $35 8 piece brass grace usa punch set online, another vice would be better too.

It's expensive as hell feeding a gun addiction
I keep telling people hookers and blow is cheaper but no one listens
 
Top Bottom