• ODT Gun Show & Swap Meet - May 4, 2024! - Click here for info

Form 1 Suppressors

Status
Not open for further replies.
If I didn’t have a lathe and machining skills, I would not try to make one. For one to work well it needs to be a few thousandths tolerance, that isn’t much room for error.

You need to get an alignment rod to make sure it will clear, it’s a whole 6 dollars from mcmaster carr. Cmshoots posted this chart
c968a468835d68a49a1f89bbaf6548da.jpg



Sent from my iPhone using Tapatalk
 
This got me into looking into form 1 paper work, but god Deng is it a lot of paperwork to fill out! Probably run down to the local Leo for finger prints so I know it’s done correctly. I wish silencer shop would offer the form 1 full time


Sent from my iPhone using Tapatalk
 
Well boys. The ride is over.

I went to QRF on the way back from the beach yesterday. First time there, and the guys are cool. @sovietak474u talked me into a Warlock 2. So I sold my Form 1 to a friend off site who is gonna finish it.

This was fun, but for the price, I’m keeping it real with the guys who do it for a living.

AD57255B-AC0B-4A45-8373-D795CB631974.jpeg
 
Status
Not open for further replies.
Back
Top Bottom