• ODT Gun Show & Swap Meet - May 4, 2024! - Click here for info

CZ Scorpion Evo 3 S1 Barrel Nut Removal...!!!

Only problem is that you'll melt the polymer in the process.
mine didn't melt when I changed the barrel and handguards. it's meant to withstand the heat of the barrel, but YMMV

IMG_2731.jpeg
 
Use debonder on the threads every few hours...then use the HB wrench but its gonna take a good bit of torque...that or the MI socket are about the only choices you have....unfortunately
 
mine didn't melt when I changed the barrel and handguards. it's meant to withstand the heat of the barrel, but YMMV
Same here, heated mine with a mini torch. I wrapped the factory hand guard in aluminum foil just to try and save it from burning, not melting. After heating it I put it on the floor and stood on it and wrenched it off.
 

Attachments

  • 09EFFD85-B784-4B69-ACED-CAFD2BC1FF7B.jpeg
    09EFFD85-B784-4B69-ACED-CAFD2BC1FF7B.jpeg
    232.9 KB · Views: 19
Back
Top Bottom