80% lone wolf $50

[bubonic]

Freedom Wolf 80% Frame (Compact/Bare)

Lone Wolf's FreedomWolf 80% Glock frame. Fits both Gen3 & Gen4 Glock 19, G23, G32, and G38 slides. No FFL needed. Assembly kit/instructions included.

www.lonewolfdist.com

Kinda backwards it gives a 125 discount at the end of checkout. 50 bucks shipped to me.

 

[Ken in West GA]

Thanks for sharing.

 

[falken]

Nice pretty cool!

 

[will4me]

Thanks just ordered another one of these, and they are nice pistols.

 

[EVILWS6]

Thanks just ordered another one of these, and they are nice pistols.

View attachment 3739142

Nice. But how much is the jig to do the lower. Then the slide, barrel, etc..? Wouldn't it be cheaper/better to just buy a factory Glock?

 

[bubonic]

Nice. But how much is the jig to do the lower. Then the slide, barrel, etc..? Wouldn't it be cheaper/better to just buy a factory Glock?

Jig comes with. Zaffiri has deals among others you could piece together a 19 for 350ish give or take. If you are a DIY person that is.

Day 19 Deal - G19 Gen 3 - EDC - No Optic Cut with Barrel and FREE UPK! - Zaffiri Precision

Day 19 - G19 Gen 3 - EDC - No Optic Cut with Barrel and FREE UPK!

zaffiriprecision.com

 

[will4me]

Nice. But how much is the jig to do the lower. Then the slide, barrel, etc..? Wouldn't it be cheaper/better to just buy a factory Glock?

Took me 15 minuets from start to finish to drill the holes and get rid of the tabs inside the frame.

I build 80% pistols, rifles all the time.

Took 15 minuets to complete the frame once the glue dried (that took 48 hours for glue to dry).

Working pistol was done quickly and the trigger on this one is better than my Glock 19 gen5

Couple of good videos online on how to complete these lowers.

Is compatible with gen 3 - 5 slides too.

 

[bulletpaluza]

Dang how can I pass this up?

 

[bigt61]

Took me 15 minuets from start to finish to drill the holes and get rid of the tabs inside the frame.

I build 80% pistols, rifles all the time.

Took 15 minuets to complete the frame once the glue dried (that took 48 hours for glue to dry).

Working pistol was done quickly and the trigger on this one is better than my Glock 19 gen5

Couple of good videos online on how to complete these lowers.

Is compatible with gen 3 - 5 slides too.

I don’t see where it says Gen 5 slide compatible

i see 3 and 4 Gen though!

 

[will4me]

Do these just need a standard gen 3 locking block?

Like this one: