• ODT Gun Show & Swap Meet - May 4, 2024! - Click here for info

Search results for query: *

  1.

    Tune the Rossi R92 at nearly zero cost, no cutting, grinding, sanding or other highly skilled butchery of factory controlled metal parts is required

    Thanx for these fixes ! My 20" 44 musta been built on a good day and was quite a nice change over the 357 that was my first R92. 👍 The 357 was a beast to load ! The gate area was super sharp and rounds had to go in just right or get pinched. The mag spring was the same length as the 20"...

  2. What is up with folks paying a gunsmith to clean their guns?!

    Clean a Glock ? Unheard of 😵‍💫🇺🇸😵‍💫
  3.

    Basic Pin & Weld

  4. Basic Pin & Weld

    Reckon its silver soldered in ?
  5.

    Basic Pin & Weld

    Have you tested it yet ?
  6.

    need to borrow/buy a barrel nut wrench for an anderson type barrel nut

    Mine was $22 😁😁
  7.

    need to borrow/buy a barrel nut wrench for an anderson type barrel nut

    Buy one man. Itsa musthave 👍🇺🇸😎
  8.

    My Grandfathers old S&W

    Gr8 job !

  9. Where are the Upper and Lower builds threads

    Under gunsmithing & repairs
  10.

    AR triggers (10)

    I like the ALG ACT trigger.
  11.

    Ak Crown

    Its not accurate enuff to know any better.

  12. Cut ,thread and crown an AR barrel on the southside of Atl. ?

    14.5" Midlength gas system cut down to 12.5".
  13.

    This AK Stock. Honest Opinion Please

    Looks koool to me. Even better with some wear 👍👍

  14. Pin and weld on the north side

    Probably do it while you shop too ;)
  15.

    Can anyone ID this trigger?

    If it feels like a better than plain jane then it might be. Id swap in a purple spring and see if its even better.
  16.

    Drilled a little into barrel, scrap or okay to use?

    Honestly . I drilled through one time. Nothing was hanging down so I went ahead and put the front sight on as planned and it was fine ;)
  17.

    Mini grease gun

    👍👍

  18. My ar-15 has a tight spot in bbl

    Lap it out

  19. Welded Flash Hider

    Break out the grinder and ease down the weld to the pin. Take out the pin. Take off the glash hider ;)
  20.

    First rifle build

    👍👍👍👍
Back
Top Bottom